Diagnostic Trouble Code Diagnosis; Clearing Trouble Codes; Diagnostic Trouble Codes - Daewoo MATIZ Service Manual

DIAGNOSTIC TROUBLE CODE DIAGNOSIS

CLEARING TROUBLE CODES

Notice: To prevent Engine Control Module (ECM) dam-
age, the key must be OFF when disconnecting or recon-
necting the power to the ECM (for example battery
cable, ECM pigtail connector, ECM fuse, jumper cables,
etc.).When the ECM sets a Diagnostic Trouble Code
(DTC), the Malfunction Indicator Lamp (MIL) lamp will
be turned on only for type A, B and E but a DTC will be
stored in the ECM's memory for all types of DTC. If the
DTC
P0107 Manifold Absolute Pressure Sensor Low Voltage
P0108 Manifold Absolute Pressure Sensor High voltage
P0112 Intake Air Temperature Sensor Low Voltage
P0113 Intake Air Temperature Sensor High voltage
P0117 Engine Coolant Temperature Sensor Low Voltage
P0118 Engine Coolant Temperature Sensor High voltage
P0122 Throttle Position Sensor Low Voltage
P0123 Throttle Position Sensor Hig voltage
P0131 Oxygen Sensor Low Voltage
P0132 Oxygen Sensor High Voltage
P0133 Oxygen Sensor No Activity
P0137 Heated Oxygen Sensor Low Voltage
P0138 Heated Oxygen Sensor high voltage
P0140 Heated Oxygen Sensor No Activity
P0141 Heated Oxygen Sensor Heater Malfuction
P0171 Fuel Trim System Too Lean
P0172 Fuel Trim System Too Rich
P1230 Fuel Pump Relay Low Voltage
P1231 Fuel Pump Relay High Voltage
P0261 Injector 1 Low Voltage
P0262 Injector 1 high voltage
P0264 Injector 2 Low Voltage
P0265 Injector 2 high voltage
P0267 Injector 3 Low Voltage
P0268 Injector 3 high voltage
P0300 Multifle Cylinder Misfire
P1320 Crankshatft Segment Period Segment Adaptation At Limit
P1321 Crankshatft Segment Period Tooth Error
P0327 Knock Sensor Circuit Fault
P0335 Magnetic Crankshaft Position Sensor Electrical Error
DAEWOO M-150 BL2

DIAGNOSTIC TROUBLE CODES

Function
ENGINE CONTROLS 1F – 55
problem is intermittent, the MIL will go out after 10 sec-
onds if the fault is no longer present. The DTC will stay
in the ECM's memory until cleared by scan tool. Remov-
ing battery voltage for 10 seconds will clear some stored
DTCs.
DTCs should be cleared after repairs have been com-
pleted. Some diagnostic tables will tell you to clear the
codes before using the chart. This allows the ECM to set
the DTC while going through the chart, which will help to
find the cause of the problem more quickly.
Error Type
A/E
Illuminate MIL
A YES
A YES
E YES
E YES
A YES
A YES
A YES
A YES
A YES
A YES
E YES
E YES
E YES
E YES
E YES
E YES
E YES
A YES
A YES
A YES
A YES
A YES
A YES
A YES
A YES
BLINKING/ON
E YES
E YES
E YES
E YES