Step
Perform an Euro On-Board Diagnostic (EOBD)
System Check.
1
Is the system check complete?
1. Turn the ignition switch to LOCK for 10 seconds.
2. Turn the Turn the ignition switch to ON.
2
3. Listen for in-tank fuel pump operation.
Does the fuel pump operate?
1. Turn the Turn the ignition switch to ON.
2. Disconnect the fuel pump relay.
3. Connect a test light between the fuel pump relay
3
connector terminal 85 and ground.
4. Turn the Turn the ignition switch to ON.
Is the test light ON?
1. Turn the Turn the ignition switch to ON.
2. Disconnect the fuel pump relay.
3. Connect a test light between the fuel pump relay
4
connector terminal 66 and B+.
4. Turn the Turn the ignition switch to ON.
Is the test light ON?
1. Turn the ignition switch to LOCK.
2. Connect a test light between the fuel pump relay
5
connector terminal 30 and ground.
Is the test light ON?
Check for short to ground in the wire between the
fuel pump relay connector terminal 87 and fuel pump
6
connector.
Is the problem found?
1. Repair the wire between the fuel pump relay
connector terminal 87 and fuel pump connector
terminal 3.
2. Install the fuel pump relay.
7
3. Turn the engine OFF for 10 seconds.
4. Clear any DTCs from ECM.
5. Turn the ignition switch to ON.
Does the fuel pump operate?
1. Replace the fuel pump relay.
2. Turn the ignition OFF for 10 seconds.
8
3. Clear any DTCs from ECM.
4. Turn the Turn the ignition switch to ON.
Does the fuel pump operate?
Check for a short to ground wire between the fuel
pump relay connector terminal 66 and the ignition
9
after key ON 1(IGN 1).
Is the problem found?
Check for a short to ground wire between the fuel
pump relay connector terminal 85 and the ECM
10
connector terminal 10.
Is the problem found?
DAEWOO M-150 BL2
DTC P1230 – Fuel Pump Relay Low Voltage
Action
ENGINE CONTROLS 1F – 115
Value(s)
Yes
–
Go to Step 2
Go to
"Diagnostic
Aids"
2.55 seconds
–
Go to Step 4
–
Go to Step 5
–
Go to Step 6
–
Go to Step 7
2.55 seconds
Go to Step 14
2.55 seconds
Go to Step 14
–
Go to Step 11
–
Go to Step 12
No
Go to
"On-Board
Diagnostic
System Check"
Go to Step 3
Go to Step 10
Go to Step 9
Go to Step 8
Go to Step 8
–
Go to Step 9
Go to Step 10
Go to Step 13
Need help?
Do you have a question about the MATIZ and is the answer not in the manual?