Making Connections - Canon ImageRunner iR8500 Series Service Manual

Chapter 18

18.2.3 Making Connections

iR105i/iR105+ / iR9070 / iR85+ / iR8070
Connect the main body and PC.
[Preparation]
Materials to be prepared
- PC, which has installed SST V3.30 or later and registered system software for this machine.
- Twist pair crossing cable
10Base-T: category 3 or 5
100Base-TX: category 5
[Procedure]
1) Start PC.
2) Confirm network setting of PC.
2-1) Start command prompt, input "IPCONFIG" and press Return key.
2-2) Check if the address of the network setting is as follows. If not, change the network setting.
IP address: 172.16.1.160
Subnet Mask: 255.255.255.0
Default Gateway: any
Do not specify following IP address.
- 172.16.1.0
- 172.16.1.100
- 172.16.1.255
3) Confirm "Execute/Memory lamp" of Control unit is turned off. Following next procedure, turn the main power switch OFF.
3-1) Press the power switch of control unit for 3 sec. or longer.
3-2) Operate following the instruction indicated on the control panel, and prepare to turn the main power switch OFF. (Shutdown sequence)
3-3) Turn OFF the main power switch.
4) Connect the machine with PC using crossing cable.
5) Start the machine with proper operation depending on download mode to be used.
- Normal mode
Press 1 and 7 in numeric keypad simultaneously and turn the main power switch ON. After starting, select Service mode COPIER > FUNCTION >
SYSTEM > DONWLOAD.
- Safe mode
18-8
F-18-11
F-18-12
0008-9111