Radiator Cooling Fan Assembly Removal And Installation; Radiator On-Vehicle Inspection And Cleaning; Radiator Removal And Installation; Water Pump Removal And Installation - Suzuki GRAND VITARA 2005 Service Manual

1F-9 Engine Cooling System:
Radiator Cooling Fan Assembly Removal and
Installation
Removal
1) Disconnect negative (–) cable at battery.
2) Disconnect connectors (1) of cooling fan motors.
3) With hose connected, detach P/S fluid reservoir with
reservoir bracket.
4) Remove air cleaner case and air cleaner suction
pipe (2).
5) Remove degassing tank (1) from radiator.
6) Remove cooling fan assembly.
CAUTION
!
Be sure not to damage condenser inlet pipe.
Installation
Reverse removal procedure for installation noting the
following.
• Refill cooling system referring to "Cooling System
Refilling: ".
• After installation, verify there is no coolant leakage at
each connection.

Radiator On-Vehicle Inspection and Cleaning

Inspection
Check radiator for leakage or damage. Straighten bent
fins, if any.
Cleaning
Clean frontal area of radiator cores.
S5JB0B1606011

Radiator Removal and Installation

Removal
1) Disconnect negative cable at battery.
1
2) Drain coolant referring to "Cooling System Draining:
I5JB0B160010-01
".
3) Remove cooling fan assembly referring to "Radiator
Cooling Fan Assembly Removal and Installation: ".
4) Remove radiator inlet and outlet hose from radiator.
5) Remove radiator from vehicle.
Installation
1
Reverse removal procedures, noting the following.
2
• Refill cooling system referring to "Cooling System
Refilling: ".
• After installation, verify there is no coolant leakage
each connection.

Water Pump Removal and Installation

Removal
I5JB0B160012-01
1) Drain coolant referring to "Cooling System Draining:
".
2) Remove timing belt referring to "Timing Belt and Belt
Tensioner Removal and Installation: in Section 1D".
3) Remove water pump assembly (1).
S5JB0B1606012
I2RH01160014-01
S5JB0B1606013
S5JB0B1606020
I5JB0B160008-01