Scan Tool Data (A/T) - Suzuki Liana RH418 Supplementary Service Manual

Scan Tool Data
As the data values given in the following table are standard values estimated on the basis of values obtained from the
normally operating vehicles by using a scan tool, use them as reference values. Even when the vehicle is in good
condition, there may be cases where the checked value does not fall within each specified data range. Therefore,
judgment as abnormal should not be made by checking with these data alone.
Also, condition in the following table that can be checked by the scan tool are those detected by TCM and output from
TCM as commands and there may be cases where the automatic transaxle or actuator is not operating (in the
condition) as indicated by the scan tool.
NOTE
The following scan tool data related to automatic transaxle can be checked only by communicating
with TCM.
Scan tool data
GEAR POSITION
ENGINE SPEED
INPUT SHAFT REV
OUTPUT SHAFT
REV
BATTERY VOLT.
ATF TEMP.
SHIFT SOL #1
COM: *** MON:***
SHIFT SOL #2
COM: *** MON:***
TCC SOL COM: ***
MON:***
PRESS CONT SOL At vehicle stop, closed throttle and 1st gear
VEHICLE SPEED
O/D OFF SWITCH
(MON)
TRANS. RANGE
Vehicle condition
Selector lever is in "P" position
Selector lever is in "R" position
Selector lever is in "N" position
Ignition switch ON
Selector lever is in "D" position
Selector lever is in "2" position
Selector lever is in "L" position
At engine idle speed
At engine idle speed and selector lever is in "P"
position
At 60 km/h (37.5 mile/h) constant speed, O/D off
switch ON, 20% or less throttle opening and 3rd gear
("D" range)
At vehicle stop
At 60 km/h (37.5 mile/h) constant speed, O/D off
switch ON, 20% or less throttle opening and 3rd gear
Ignition switch ON and engine stop
After driving at 60 km/h (37.5 mile/h) for 15 minutes or
more, and A/T fluid temperature reaches 70 – 80 °C
(158 – 176 °F)
Within 3 seconds after shifting "D" to "P"
At 40 km/h (25 mile/h) constant speed, O/D off switch
ON, 20% or less throttle opening and 3rd gear
Within 3 seconds after shifting "P" to "D"
At 40 km/h (25 mile/h) constant speed, O/D off switch
ON, 20% or less throttle opening and 3rd gear
At 5 km/h (3 mile/h) constant speed, O/D off switch
OFF, closed throttle and 1st gear
At 80 km/h (50 mile/h) constant speed, O/D off switch
OFF, 20% or less throttle opening and 4th gear
At vehicle stop
O/D off switch OFF
Ignition switch ON
O/D off switch ON
Selector lever is in "P" position
Selector lever is in "R" position
Selector lever is in "N" position
Ignition switch ON
Selector lever is in "D" position
Selector lever is in "2" position
Selector lever is in "L" position
Automatic Transmission/Transaxle:
Normal condition / reference
values
Engine idle speed is displayed
(Engine idle speed is displayed in
increments of 50 rpm)
2150 RPM
(displayed in increments of 50 rpm)
0 RPM
2150 RPM
(displayed in increments of 50 rpm)
9 – 16 V
70 – 80 °C (158 – 176 °F)
0 KM/H, 0 MPH
5A-19
S3RH0B5104009
P or N
R
P or N
1st
1st
1st
ON
OFF
ON
ON
OFF
ON
9.5%
OFF
ON
P
R
N
D
2
L