Call For Service Fuser Lamp - Minolta magicolor 330 Service Manual

3.40 - Error Message: Call for Service Fuser Lamp
There is a problem with the Fuser Lamp control.
Logic control on the MCU PWB detected that the Fuser Lamp remained on longer than the specified time.
Step
SUSPECT COMPONENTS
The following components are associated with this specific prob-
lem. One or more of these components may have failed partially
or completely. If you cannot isolate the problem using this FIP,
replace each component listed below, one at a time, until the prob-
lem disappears.
• Main Fuser Assembly (RRP 9.81)
• Wiring and connectors linking the components
1
Replace the Temperature Sensor Assembly (RRP 9.88)
Does the error message still appear?
2
Replace the MCU PWB (RRP 9.123)
Does the error message still appear?
3
Replace the LVPS Assembly (RRP 9.119)
Does the error message still appear?
magicolor 330 - Base Engine Service Manual
Actions and Questions
Primary FIPS: Error Messages
Yes No
Go to step 2 Problem
solved
Go to step 3 Problem
solved
Go to suspect Problem
components solved
3-45