Minolta magicolor 330 Service Manual page 355

RRP 9.103 Full Stack Sensor (PL10.2.21)
Removal
1. Remove the Lower Exit Assembly (RRP 9.101).
2. Remove the screw securing the Full Stack Sensor to the Lower Exit Assembly.
3. Release the Full Stack Sensor wire harness from the wire clamp.
4. Disconnect P/J167 from the Sensor and remove the Sensor.
Replacement
1. Reconnect P/J167 to the Full Stack Sensor.
2. Route the Full Stack Sensor wire harness through the wire clamp.
3. Reinstall the Full Stack Sensor onto the Lower Exit Assembly and use one screw to secure the Sensor.
4. Reinstall the Lower Exit Assembly (RRP 9.101).
magicolor 330 - Base Engine Service Manual
Removal and Replacement Procedures
9-211