Minolta magicolor 330 Service Manual page 299

RRP 9.75 2nd BTR Assembly (PL8.1.20)
Removal
1. Remove the Transfer Assembly (RRP 9.71).
2. Remove the Belt Cleaner Assembly (RRP 9.76).
3. Reach through the empty Fuser Assembly cavity and slide the 2nd BTR Assembly out of the IBT Front
and Rear Brackets and out of the printer.
Replacement
1. Position the 2nd BTR so the gears face the rear of the printer and place the 2nd BTR Assembly on the
frame inside the empty Fuser cavity.
2. Place your left hand on the rear of the 2nd BTR and place your right hand on the front of the 2nd BTR
and push the 2nd BTR into the slots in the IBT Front and Rear Brackets.
3. Push hard on both ends to make sure the 2nd BTR has seated correctly.
4. Reinstall the Belt Cleaner Assembly (RRP 9.76).
5. Reinstall the Transfer Assembly (RRP 9.71).
6. Refer to Section 9 of this manual and reset the 2nd BTR Assembly Life Counter to zero.
magicolor 330 - Base Engine Service Manual
Removal and Replacement Procedures
9-155