Adjust Upper Bin - Minolta magicolor 330 Service Manual

Primary FIPS: Error Messages
3.39 - Error Message: Adjust Upper Bin
There is a problem with the Upper Bin.
Logic control on the MCU PWB did not detect the Upper Bin installed in Feeder 1.
Step
SUSPECT COMPONENTS
The following components are associated with this specific prob-
lem. One or more of these components may have failed partially or
completely. If you cannot isolate the problem using this FIP,
replace each component listed below, one at a time, until the prob-
lem disappears.
• Wiring and connectors linking the components
1
UPPER BIN INSPECTION
1. Remove the Upper Bin from Feeder 1.
2. Inspect the Size Actuators at the rear of the Tray.
Are the Actuators intact and free of damage?
2
Replace the Size Switch Assembly (RRP 9.17)
Does the error message still appear?
3
Replace the MCU PWB (RRP 9.123)
Does the error message still appear?
3-44
Actions and Questions Yes
Go to step 2
Go to step 3
Go to suspect
components
magicolor 330 - Base Engine Service Manual
No
Replace the
Upper Bin.
Problem
solved
Problem
solved