Minolta magicolor 330 Service Manual page 381

RRP 9.116 Dispense Motor Assembly (PL11.1.22)
Removal
1. Remove the Rotary Motor PWB (RRP 9.115).
2. Remove the two screws securing the Dispense Motor to the printer frame.
3. Slide the Dispense Motor up and slightly to the left to free the Motor shaft gear from the frame, and
remove the Motor (inset).
4. Disconnect P/J 55 from the Dispense Motor.
Replacement
1. Reconnect P/J 55 to the Dispense Motor.
2. Position the Dispense Motor so the P/J connector is facing to the right.
3. Reinstall the Dispense Motor by inserting the Motor shaft gear into the large key slot then sliding the
Motor down so the shaft rests in the large key slot (inset).
4. Line up the two screw holes in the Motor with the two screw holes in the printer frame.
5. Use two screws to secure the Motor to the frame.
6. Reinstall the Rotary Motor PWB (RRP 9.115).
magicolor 330 - Base Engine Service Manual
Removal and Replacement Procedures
9-237