Minolta magicolor 330 Service Manual page 371

RRP 9.111 Paper Handling Motor Assembly (PL11.1.3)
Removal
1. Remove the Rear Cover (RRP 9.4).
2. Disconnect P/J 49 and P/J 50 from the Paper Handling Motor PWB.
3. Remove the five screws securing the Paper Handling Motor Assembly to the Fuser Drive Assembly
and remove the Motor Assembly.
4. Remove the two Motor Supports.
Replacement
1. Reinstall the two Motor Supports between the Motor and the Motor PWB.
2. Reinstall the Paper Handling Motor Assembly onto the Fuser Drive Assembly by inserting the motor
shaft into the cutout in the Fuser Drive Assembly.
3. Line up the five screw holes in the Motor Assembly with the four screw holes in the Fuser Drive
Assembly.
4. Use four screws to secure the Paper Handling Motor Assembly to the Fuser Drive Assembly.
5. Reconnect P/J 49 and P/J 50 to the Paper Handling Motor PWB.
6. Reinstall the Rear Cover (RRP 9.4).
magicolor 330 - Base Engine Service Manual
Removal and Replacement Procedures
9-227