Waste Toner Nearly Full - Minolta magicolor 330 Service Manual

Primary FIPS: Error Messages
3.72 - Error Message: Waste Toner Nearly Full
The Waste Toner Box is almost full.
Logic control on the MCU PWB detected that the Waste Toner Box is almost full and will soon need to be replaced.
Step
SUSPECT COMPONENTS
The following components are associated with this specific prob-
lem. One or more of these components may have failed partially
or completely. If you cannot isolate the problem using this FIP,
replace each component listed below, one at a time, until the prob-
lem disappears.
• Wiring and connectors linking the components
1
Replace the Waste Toner Box (RRP 9.49).
Does the error message still appear?
2
Replace the Waste Toner Sensor (RRP 9.53).
Does the error message still appear?
3-72
Actions and Questions Yes
Go to step 2
Replace the
MCU PWB
(RRP 9.123)
magicolor 330 - Base Engine Service Manual
No
Problem
solved
Problem
solved