Exit Cover Open - Minolta magicolor 330 Service Manual

Primary FIPS: Error Messages
3.58 - Error Message: Exit Cover Open
There is a problem with the Exit Cover.
Logic control on the MCU PWB detected that the Exit Cover Interlock Switch is deactuated.
Step
SUSPECT COMPONENTS
The following components are associated with this specific prob-
lem. One or more of these components may have failed partially
or completely. If you cannot isolate the problem using this FIP,
replace each component listed below, one at a time, until the prob-
lem disappears.
• Wiring and connectors linking the components
1
EXIT COVER RESEAT
1. Open the Exit Cover.
2. Firmly close the Exit Cover.
Does the error message still appear?
2
EXIT COVER ACTUATOR INSPECTION
1. Open the Exit Cover.
2. Inspect the Exit Cover Interlock Switch actuator that is
located at the top-rear of the Cover.
Is the actuator free of damage?
3
Replace the Exit Cover Switch (RRP 9.107)
Does the error message still appear?
3-62
Actions and Questions Yes
Go to step 2
Go to step 3
Replace the
MCU PWB
(RRP 9.123)
magicolor 330 - Base Engine Service Manual
No
Problem
solved
Replace the
Upper Exit
Assembly
(RRP 9.102)
Problem
Solved