Belt Cleaner Life Low - Minolta magicolor 330 Service Manual

Primary FIPS: Error Messages
3.68 - Error Message: Belt Cleaner Life Low
The Belt Cleaner is nearing end of life.
Logic control on the MCU PWB detected that the BTR Cleaner processed 100,000 sheets of paper.
Step
SUSPECT COMPONENTS
The following components are associated with this specific prob-
lem. One or more of these components may have failed partially
or completely. If you cannot isolate the problem using this FIP,
replace each component listed below, one at a time, until the prob-
lem disappears.
• Wiring and connectors linking the components
1
Go to Section 8 and follow the instructions on how to read the Belt
Cleaner Life Counter and compare that data with any know data
regarding the age and usage level of the current Belt Cleaner.
Has the printer engine truly processed at least 100,000 sheets
of paper since the Belt Cleaner was last replaced?
2
MCU/NVRAM STABILITY TEST
1. Write to NVRAM what you believe to be the correct Belt
Cleaner Life Count reading for the printer.
2. Generate 100 test prints.
3. Reread the Belt Cleaner Life Counter.
Does the Belt Cleaner BTR Life Counter display the Life
Count reading you just entered, plus 100 prints?
3-68
Actions and Questions Yes
Deal with the
matter accord-
ing to your
company pol-
icy or replace
the Belt
Cleaner
Assembly
(RRP 9.76).
Treat as an
intermittent. If
problem reoc-
curs, replace
the MCU
PWB (RRP
9.123)
magicolor 330 - Base Engine Service Manual
No
Go to step 2
Replace the
MCU PWB
(RRP 9.123)