Minolta magicolor 330 Service Manual page 393

RRP 9.122 Developer Fan (PL13.1.5)
Removal
1. Remove the Rear Cover (RRP 9.4).
2. Disconnect P/J 82 from the Developer Fan.
3. Pull out on the two Fan latches as you press the Developer Fan out of the Fan Duct.
Replacement
1. Position the Developer Fan against the Developer Fan Duct so the label on the Fan faces out and the
Fan wires are next to the cutout that is located in the bottom of the Duct.
2. Pull out on the two Fan latches as you press the Developer Fan into the Fan Duct.
The Fan snaps into place.
3. Reconnect P/J 82 to the Developer Fan.
4. Reinstall the Rear Cover (RRP 9.4).
magicolor 330 - Base Engine Service Manual
Removal and Replacement Procedures
9-249