Minolta magicolor 330 Service Manual page 385

RRP 9.118 Developer Tie Plate (PL12.1.4)
Removal
1. Remove the Lower Exit Assembly (RRP 9.101).
2. Remove the Rear Cover (RRP 9.4).
3. Remove the Inner Cover (RRP 9.2).
4. Remove the wire and Wire Clamp from the Developer Tie Plate.
5. Remove the two screws securing the Developer Tie Plate to the rear of the printer frame.
6. Remove the two screws securing the Developer Tie Plate to the front of the printer frame.
7. Slide the Tie Plate up and out of the printer frame.
Replacement
1. Position the Developer Tie Plate as shown.
2. Slide the Tie Plate down into position, behind the P/J connectors that are located on the rear of the
printer frame.
3. Use two screws to secure the Developer Tie Plate to the front of the printer frame.
4. Use two screws to secure the Developer Tie Plate to the rear of the printer frame.
5. Reinstall the Wire Clamp and wire onto the Developer Tie Plate.
6. Reinstall the Inner Cover (RRP 9.2).
7. Reinstall the Rear Cover (RRP 9.4).
8. Reinstall the Lower Exit Assembly (RRP 9.101).
magicolor 330 - Base Engine Service Manual
Removal and Replacement Procedures
9-241