Minolta magicolor 330 Service Manual page 403

RRP 9.127 Controller Chassis Assembly (PL14.1.1)
Removal
1. Remove the Controller Fan (RRP 9.128).
2. Remove the Controller PWB (RRP 9.129).
3. Slide the Main Paper Handling Assembly several inches out of the printer engine.
4. Loosen, but do not remove, the four screws securing the bottom of the Controller Chassis Assembly to
the printer frame.
5. Remove the four screws securing the top of the Controller Chassis Assembly to the printer frame.
6. Lift the Controller Chassis Assembly up and off of the four loosened screws at located at the bottom of
the Chassis, and remove the Chassis Assembly from the printer frame.
Replacement
1. Slide the Main Paper Handling Assembly several inches out of the printer engine.
2. Lower Controller Chassis Assembly onto the printer frame so the four notches located at the bottom of
the Controller Chassis Assembly slide behind the four loosened screws on the printer frame.
3. Use four screws to secure the top of the Controller Chassis Assembly to the printer frame.
4. Tighten the four screws at the bottom of the Controller Chassis Assembly.
5. Reinstall the Controller PWB (RRP 9.129).
6. Reinstall the Controller Fan (RRP 9.128).
magicolor 330 - Base Engine Service Manual
Removal and Replacement Procedures
9-259