Waste Toner Box Missing - Minolta magicolor 330 Service Manual

3.32 - Error Message: Waste Toner Box Missing
The Waste Toner Box is not installed.
Logic control on the MCU PWB detected that the Waste Toner Box Sensor was deactuated.
Step
SUSPECT COMPONENTS
The following components are associated with this specific prob-
lem. One or more of these components may have failed partially
or completely. If you cannot isolate the problem using this FIP,
replace each component listed below, one at a time, until the prob-
lem disappears.
• Wiring and connectors linking the components
• Waste Toner Box (RRP 9.49)
• OPC Drum (RRP 9.48)
1
WASTE TONER BOX RESEAT
1. Open the Front Cover.
2. Remove the Waste Toner Box.
3. Reinstall the Waste Toner Box.
Does the error message still appear?
2
PRINTER RESTART
1. Switch off printer main power.
2. Wait one minute.
3. Switch on printer main power.
Does the error message still appear?
3
WASTE TONER BOX SENSOR TEST
1. Enter Diagnostics and test the Waste Toner Box Sensor
input test.
2. Open the Front Cover.
3. Remove the Waste Toner Box.
4. Read the test result in the Diagnostics Status Window.
5. Manually actuate the Waste Toner Box sensor inside the
Waste Toner Box cavity.
In the diagnostics, is "actuated" displayed when you manually
actuate the sensor?
4
Replace the Waste Toner Sensor (RRP 9.53)
Does the error message still appear?
magicolor 330 - Base Engine Service Manual
Actions and Questions
Primary FIPS: Error Messages
Yes No
Go to step 2 Treat
intermittent
problem.
Go to step 3 Treat
intermittent
problem.
Replace the Go to step 4
MCU PWB
(RRP 9.123)
Go to suspect Problem
components solved
as an
as an
3-35