Minolta magicolor 330 Service Manual page 251

RRP 9.51 Erase Lamp Assembly (PL6.1.30)
Removal
1. Remove the XL Rail Assembly (RRP 9.52).
2. Use a screwdriver to release the three latches holding the Erase Lamp Assembly to the XL Rail
Assembly and remove the Lamp.
Replacement
1. Route the Erase Lamp wire through the hole in the top of the printer frame.
2. Position the Erase Lamp against the XL Rail Assembly so the three latches on the Lamp line up with
the three holes in the Rail Assembly.
3. Press the Erase Lamp Assembly against the Rail Assembly so the three latches snap into place.
4. Reinstall the XP Rail Assembly (RRP 9.52).
magicolor 330 - Base Engine Service Manual
Removal and Replacement Procedures
9-107