Minolta magicolor 330 Service Manual page 241

RRP 9.46 Registration Brake Clutch (PL5.2.20)
Removal
1. Remove the Main Paper Handling Assembly (RRP 9.36).
2. Turn the Main Paper Handling Assembly over and disconnect P/J 109 from the Registration Brake
Clutch (Figure 1).
3. Remove the three screws securing the Registration Brake Clutch Assembly to the side of the Main
Paper Handling Assembly and remove the Assembly (Figure 2).
4. Remove the E ring securing the Registration Brake Clutch to the Clutch shaft and remove the Clutch
(Figure 3).
5. Remove the E ring securing the Registration Brake Gear to the Gear shaft and remove the Gear.
Replacement
1. Reinstall the Registration Brake Gear onto the Gear shaft and use an E ring to secure the Gear (Figure
3).
2. Reinstall the Registration Brake Clutch onto the Clutch shaft and use an E ring to secure the Clutch.
3. Reinstall the Registration Brake Clutch Assembly onto the side of the Main Paper Handling Assembly
making sure you thread the Clutch wire harness through the hole in the side of the Paper Handling
Assembly.
4. Use three screws to secure the Registration Brake Clutch Assembly to the Main Paper Handling
Assembly.
5. Reconnect P/J 109 to the Registration Brake Clutch (Figure 1).
6. Reinstall the Main Paper Handling Assembly (RRP 9.36).
magicolor 330 - Base Engine Service Manual
Removal and Replacement Procedures
9-97