Minolta magicolor 330 Service Manual page 117

5.9 - Spots, continued
Step
AUGER ASSEMBLY INSPECTION
With the Belt Cleaner Assembly removed, inspect the Belt Cleaner
6
end of the Auger.
Is the Auger clogged?
AUGER DRIVE TEST
1. Remove the Rear Cover (RRP 9.4).
7
2. With the Belt Cleaner Assembly removed watch the Auger
Drive Gear as you hand rotate the Paper Handling Motor.
Does the Fuser Drive Assembly rotate the Auger Drive Gear?
AUGER SPRING TEST
As you hand rotate the Paper Handling Motor place your finger
inside the Auger opening and feel the movement of the Auger
8
Spring.
Does the Auger Spring rotate when you hand rotate the Paper
Handling Motor?
WASTE TONER BOX GEAR INSPECTION
Remove the Waste Toner Box (RRP 9.49) and inspect Box.
9
Is the Waste Toner Box clean, not leaking toner, and not obvi-
ously damaged?
magicolor 330 - Base Engine Service Manual
Actions and Questions
Primary Fault Isolation Procedures
Yes
Go to step 7 Clean
printer interior
Go to step 8 Replace
Fuser
Assembly
(RRP 9.110)
Go to step 9 Replace
Auger Assem-
bly (RRP 9.77)
Replace the Replace
Xerographic Waste
Cartridge (RRP Box
9.48) 9.49)
No
the
the
Drive
the
the
Toner
(RRP
5-21