Minolta magicolor 330 Service Manual page 301

RRP 9.76 Belt Cleaner Assembly (PL8.1.30)
Removal
1. Remove the Fuser Assembly (RRP 9.80).
2. Open the Front Cover.
3. Reach in through the empty Fuser Assembly cavity and hold the bottom of the Belt Cleaner Assembly.
4. Loosen the two screws securing the Cleaner Support to the printer frame and remove the Cleaner
Support (Figure 1).
5. Slide the Belt Cleaner Assembly to the front of the printer and remove the Assembly through the Fuser
cavity (Figure 2).
Replacement
1. Reinstall the Belt Cleaner Assembly through the empty Fuser cavity.
2. Line up the mark on positioning pin at the rear of the Assembly with the mark on the positioning hole at
the rear of the printer and slide the pin into the hole.
3. Line up the two screws attached to the Cleaner Support with the screw holes in the printer frame.
4. Line up the front of the Belt Cleaner Assembly with the spring and support bar sticking out from the
Cleaner Support.
5. Tighten the two screws attached to the Cleaner Support to secure the Support and the Belt Cleaner
Assembly to the printer frame.
6. Reach in through the Fuser cavity and raise and release the Belt Cleaner Assembly to make sure the
Assembly moves freely.
7. Reinstall the Fuser Assembly (RRP 9.80).
8. Refer to Section 9 of this manual and reset the Belt Cleaner Assembly Life Counter to zero.
magicolor 330 - Base Engine Service Manual
Removal and Replacement Procedures
9-157