Minolta magicolor 330 Service Manual page 353

RRP 9.102 Upper Exit Assembly (PL10.1.2)
Removal
1. Open the Upper Exit Assembly.
2. Gently pry the Lower Exit Assembly rear pivot arm out of the pivot hole in the rear of the Upper Exit
Assembly and remove the Upper Exit Assembly.
Replacement
1. Position the Upper Exit Assembly at about a 45
2. Insert the front pivot hole of the Upper Exit Assembly into the front pivot arm of the Lower Exit Assem-
bly.
3. Push in the on the rear of the Upper Exit Assembly enough so the rear pivot arm of the Lower Exit
Assembly fits into the rear pivot hole of the Upper Exit Assembly.
4. Open and close the Upper Exit Assembly to make sure it moves smoothly.
magicolor 330 - Base Engine Service Manual
Removal and Replacement Procedures
°
angle to the printer frame.
9-209