Put <Size> Paper In Opt2 Bin - Minolta magicolor 330 Service Manual

Primary FIPS: Error Messages
3.9 - Error Message: Put <Size> paper in OPT2 Bin
OPT2 tray is out of paper.
Logic control on the MCU PWB detected that the No Paper Sensor in OPT2/Tray 3 is actuated. The Engine Diagnos-
tic Menu may refer to the the OPT2 Bin no paper sensor as Tray 3 no paper sensor.
Step
SUSPECT COMPONENTS
The following components are associated with this specific prob-
lem. One or more of these components may have failed partially
or completely. If you cannot isolate the problem using this FIP,
replace each component listed below, one at a time, until the prob-
lem disappears.
• Wiring and connectors linking the LCIF with the MCU PWB
1
LCIF TRAY INSPECTION
Slide OPT2 tray out of the LCIF.
Is the tray out of paper?
2
NO PAPER SENSOR TEST
1. Enter Diagnostics and test OPT2/Tray 3 No Paper Sen-
sor.
2. Manually actuate and deactuate the No Paper Sensor.
Is "actuated" displayed when you manually actuate the sen-
sor? And, is "not actuated" displayed when you manually
deactuate the sensor?
3
Replace the Feeder PWB (LCIF RRP 6.10)
Does the error message still appear?
4
Replace the MCU PWB (RRP 9.123)
Does the error message still appear?
3-12
Actions and Questions Yes
Load paper
into the Tray.
Go to step 3
Go to step 4
Go to suspect
components
magicolor 330 - Base Engine Service Manual
No
Go to step 2
Replace OPT2/
Tray 3 No
Paper Sensor
Assembly
(LCIF RRP
6.23)
Problem
Solved
Problem
Solved