Minolta magicolor 330 Service Manual page 343

RRP 9.97 Cleaner Cam Assembly (PL9.4.26)
Removal
1. Remove the Cleaner Cam Solenoid (RRP 9.96).
2. Remove the two screws securing the Fuser Front Rail to the Fuser Tray and remove the Rail.
3. Remove E ring securing Cleaner Cam to the Cleaner Cam Assembly shaft and remove the Cam.
4. Remove the pin from the front end of the Cleaner Cam Assembly shaft.
5. Slide the Cleaner Cam Assembly out of the Fuser Tray.
Replacement
1. Slide the rear bearing, collar facing the rear of the shaft, onto the Cleaner Cam Assembly shaft.
2. Slide the Cleaner Cam Assembly into the hole in the rear of the Fuser Tray.
3. Slide the Cleaner Cam Assembly through the Fuser Tray so the front of the Cleaner Cam Assembly
shaft exits through the front hole in the Fuser Tray.
4. Reposition the rear bearing so it fits into the bearing hole at the rear of the Fuser Tray.
5. Slide the front bearing, collar facing the front of the shaft, onto the Cleaner Cam Assembly shaft.
6. Reposition the front bearing so it fits into the bearing hole at the front of the Fuser Tray.
7. Insert the pin into the hole at the front end of the Cleaner Cam Assembly shaft.
8. Line up the slot in the rear of the Cleaner Cam with the pin at the front of the Cleaner Cam Assembly
shaft.
9. Lift the Clean Cam Guide and slide the Cleaner Cam onto the shaft, making sure the pin fits into the
slot in the rear of the Cleaner Cam.
10. Use an E ring to secure the Cam to the Cam Assembly shaft.
11. Reinstall the Fuser Front Rail and use two screws to secure the Rail to the Fuser Tray.
12. Reinstall the Cleaner Cam Solenoid (RRP 9.96).
magicolor 330 - Base Engine Service Manual
Removal and Replacement Procedures
9-199