5.14 - Damaged Prints - Minolta magicolor 330 Service Manual

Primary Fault Isolation Procedures

5.14 - Damaged Prints

RS513X
Step
FEEDER ISOLATION
Feed paper out of each of the available paper feeders
1
Is the paper damaged when fed out of one tray but not when fed
out of the others?
2
Is the paper damaged when fed out of MSI?
3 Is the paper damaged when fed out of Tray 1?
Is the paper damaged when fed out of any tray in the HCF?
4
MSI PAPER INSPECTION
5
Inspect the paper that is loaded in the MSI.
Is the paper in good condition and undamaged?
MSI INSPECTION
1. Remove the MSI Assembly (RRP 9.22).
6
2. Inspect the MSI Assembly for debris or obviously broken com-
ponents that could be damaging the paper as it feeds out of the
Assembly and into the printer.
Is the MSI free of debris or broken components?
TRAY 1 PAPER INSPECTION
7
Inspect the paper that is loaded in Tray 1.
Is the paper in good condition and undamaged?
5-30
PROBLEM
The printed page exits the printer either wrinkled, creased, or torn. THE PRINTER NEI-
THER JAMS NOR DISPLAYS AN ERROR MESSAGE.
• Main Paper Handling Assembly (RRP 9.36)
• Transfer Assembly (RRP 9.71)
• Fuser Assembly (RRP 9.80)
Actions and Questions Yes
Go to step 2
Go to step 5
Go to step 7
Go to FIP 4.2
of the HCF
Technical Man-
ual
Go to step 6
Go to step 9
Go to step 8
magicolor 330 - Base Engine Service Manual
No
Go to step 9
Go to step 3
Go to step 4
Replace the
paper with new,
undamaged
paper
Clean the MSI,
or replace the
broken compo-
nents or replace
the MSI
Assembly
(RRP 9.22)
Replace the
paper with new,
undamaged
paper