Minolta magicolor 330 Service Manual page 365

RRP 9.108 Fuser Fan (PL10.2.15)
Removal
1. Remove the Rear Cover (RRP 9.4).
2. Disconnect P/J 111 from the P/J near the top rear of the Lower Exit Assembly.
3. Spread the two latches securing the Fuser Fan to the Lower Exit Assembly and pull the Fan out of the
Assembly.
Replacement
1. Position the Fuser Fan so the label faces out and the wires exit the Fan at the top right.
2. Spread the two latches on the Lower Exit Assembly and push the Fuser Fan into the Assembly.
The latches lock the Fan into place in the Lower Exit Assembly.
3. Reconnect P/J 111 to the P/J near the top rear of the Lower Exit Assembly.
4. Reinstall the Rear Cover (RRP 9.4).
magicolor 330 - Base Engine Service Manual
Removal and Replacement Procedures
9-221