Minolta magicolor 330 Service Manual page 249

RRP 9.50 ADC Sensor Assembly (PL6.1.20)
Removal
1. Remove the Xerographic Cartridge (RRP 9.48).
2. Remove the Inner Cover Assembly (RRP 9.2).
3. Disconnect P/J 81 from the ADC Sensor Assembly.
4. Remove the E ring securing the front of the ADC Sensor Assembly to the front of the printer frame.
5. Reach inside the printer cavity and slide the front end of the ADC Sensor out of the hole at the front of
the printer.
6. Pull the wire harness and P/J 81 out through the grommet hole.
7. Lift the rear end of the ADC Sensor out of the cutout at the rear of the printer and remove the ADC
Sensor.
The IBT is located next to the ADC Sensor Assembly. The IBT is easily scratched. When
removing the ADC Sensor be extremely careful that you do not touch the surface of the
IBT with your fingers or with the ADC Sensor Assembly.
Replacement
1. Slide the shaft end of the ADC Sensor Assembly into the slot at the rear of the printer cavity.
2. Push the shaft far enough to the rear for you to slide the front of the shaft into the hole in the front of
the printer frame and the positioning tab into the slot next to the hole.
3. Slide the rear of the shaft down into the rear slot.
4. Insert P/J 81 through the grommet hole.
5. Use an E ring to secure the front of the ADC Sensor Assembly to the front of the printer frame.
6. Reconnect P/J 81.
7. Reinstall the Inner Cover Assembly (RRP 9.2).
8. Reinstall the Xerographic Cartridge (RRP 9.48).
magicolor 330 - Base Engine Service Manual
Removal and Replacement Procedures
9-105