Minolta magicolor 330 Service Manual page 397

RRP 9.124 Front Cover Switch R (PL13.2.3)
Removal
1. Remove the Controller Chassis Assembly (RRP 9.127).
2. Disconnect the P/J191, P/J192, P/J193, and P/J194 from the Front Cover Switch R.
Mark the wires for correct replacement.
3. Squeeze the two latches on the side of the Front Cover Switch as you push the Switch out of the front
of the printer frame.
Replacement
1. Slide the Front Cover Switch into the cutout in the front of the printer frame.
The latches snap into place.
2. Reconnect the P/J191, P/J192, P/J193, and P/J194 to the Front Cover Switch.
3. Reinstall the Controller Chassis Assembly (RRP 9.127).
magicolor 330 - Base Engine Service Manual
Removal and Replacement Procedures
9-253