Minolta magicolor 330 Service Manual page 123

5.12 - Toner on Back of Print, continued
Step
FUSER INSPECTION
1. Generate a test print and slide the Fuser Assembly out of the
printer just as the sheet of paper exits the Fuser.
4
2. Slide the Fuser Assembly out of the printer and inspect the back
of the sheet of paper.
Is the back of the sheet of paper clean and free of toner when it
exits the Fuser?
UPPER EXIT INSPECTION
1. Generate a test print and open the Upper Exit Cover just as the
sheet of paper reaches Exit Roll 3.
5
2. Inspect the back of the sheet of paper.
Is the back of the sheet of paper clean and free of toner as it
nears Exit Roll 3?
magicolor 330 - Base Engine Service Manual
Actions and Questions
Primary Fault Isolation Procedures
Yes
Go to step 5 Clean the Fuser
Assembly and/
or replace the
Pressure
(RRP 9.83) and
the Heat Roll
(RRP 9.84)
Clean the Clean
printer interior replace
Upper
Assembly
(RRP 9.102)
No
Roll
or
the
Exit
5-27