Minolta magicolor 330 Service Manual page 401

RRP 9.126 Environment Sensor (PL13.2.5)
Removal
1. Remove the Xerographic Cartridge (RRP 9.48).
2. Slide the Main Paper Handling Assembly out of the printer.
3. Disconnect P/J 105 from the Environment Sensor.
4. Remove the screw securing the Ground Wire and the Environment Sensor to the printer frame, push
the Wire aside and remove the Sensor.
Replacement
1. Reinstall the Environment Sensor onto the printer frame.
2. Align the Sensor so the positioning hole and the screw hole in the Sensor line up with the positioning
tab and screw hole in the printer frame.
3. Reinstall the Ground Wire over the screw hole in the Sensor.
4. Use one screw to secure the Sensor and Ground Wire to the frame.
5. Reconnect P/J 105 to the Environment Sensor.
6. Slide the Main Paper Handling Assembly into the printer.
7. Reinstall the Xerographic Cartridge (RRP 9.48).
magicolor 330 - Base Engine Service Manual
Removal and Replacement Procedures
9-257