Minolta magicolor 330 Service Manual page 181

Minolta laser printer service manual
Table of Contents

Advertisement

RRP 9.16 Turn Roll Assembly (PL3.1.11)
Removal
1. Remove Tray 1 from the printer.
2. Remove the Main Paper Handling Assembly (RRP 9.36).
3. Remove the two screws securing the Turn Chute to the printer frame and remove the Turn Chute.
4. Remove the Turn IN Chute (RRP 9.20).
5. Remove the two screws securing the Tray Stopper to the printer frame and remove the Stopper.
6. Remove the E ring securing the front of the Turn Roll Shaft to the front bearing.
7. Disconnect the Turn Arm Spring from the printer frame.
8. Remove the E ring securing the round cover that is over the Turn Arm Assembly Gear and remove the
cover.
9. Slide the rear of the Turn Roll Shaft out of the Turn Arm Assembly.
10. Slide the front of the Turn Roll Shaft out of the front bearing and remove the Turn Roll Assembly.
Replacement
1. Slide the front bearing over the front of the Turn Roll Shaft.
2. Slide the front of the Turn Roll Shaft through the cutout in the front of the frame.
3. Push the Shaft far enough through the cutout so you can slide the rear of Shaft into the Turn Arm
Assembly.
4. Reinstall the round cover over the Turn Arm Assembly Gear and use an E ring to secure the cover to
the Gear.
5. Reconnect the Turn Arm Spring to the printer frame.
6. Use an E ring to secure the front of the Turn Roll Shaft to the front bearing.
7. Reinstall the Tray Stopper to the printer frame and use two screws to secure the Stopper to the frame.
8. Reinstall the Turn IN Chute (RRP 9.20).
9. Push in on the rear arm of the Turn IN Chute and insert the arm into the hole in the rear of the frame.
10. Reinstall the Turn Chute onto the printer frame, making sure you slide the bottom of the Chute under
the Turn Roll Assembly so the four Turn Rolls fit through the opens in the Chute.
11. Use two screws to secure the Turn Chute to the printer frame.
12. Reinstall the Main Paper Handling Assembly (RRP 9.36).
13. Reinstall Tray 1 into the printer.
magicolor 330 - Base Engine Service Manual
Removal and Replacement Procedures
9-37

Advertisement

Table of Contents
loading

Table of Contents