Table of Contents
Advertisement
RRP 9.32 MSI Clutch (PL4.2.26)
Removal
1. Remove the MSI Rear Cover (RRP 9.24).
2. Disconnect P/J 202B.
3. Turn the MSI upside down and remove the three screws securing the MSI Holder to the MSI Frame
and remove the Holder.
4. Disconnect the Pick Up Spring from the Clutch Bracket.
5. Remove the two screws securing the Clutch Bracket to the MSI Frame and carefully remove the
Bracket.
6. Remove the MSI Gear from the MSI Shaft.
7. Remove the MSI Clutch from the MSI Frame.
8. Slide the MSI Shaft out of the MSI Clutch.
Replacement
1. Position the MSI Shaft so the end with the attached E ring is away from the MSI Clutch.
2. Slide the MSI Shaft through the hole in the MSI Clutch.
3. Position the MSI Clutch so the Clutch gear faces the MSI Frame.
4. Insert the large end of the MSI Shaft into the MSI Rear Bearing.
5. Make sure the MSI Front Bearing is in place in the Clutch Bracket.
6. Carefully reinstall the Clutch Bracket by first making sure the key, the metal tab located next to the
screw hole, traps the notch in the Clutch.
7. Insert the free end of the MSI Shaft through the MSI Front Bearing in the Clutch Bracket.
8. Press the Clutch Bracket against the MSI Frame, and reposition the Bracket so the two screw holes
line up with the two screw holes in the Frame.
9. Use two screws to secure the Bracket to the Frame.
10. Reconnect the Pick Up Spring to the Clutch Bracket.
11. Reinstall the MSI Holder and use three screws to secure the Holder to the MSI Frame.
12. Reconnect P/J 202B.
13. Reinstall the MSI Rear Cover (RRP 9.24).
magicolor 330 - Base Engine Service Manual
Removal and Replacement Procedures
9-69
Advertisement
Chapters
Table of Contents
