Minolta magicolor 330 Service Manual page 187

RRP 9.19 Low Paper Sensor (PL3.1.35)
Removal
1. Remove Tray 1 from the printer.
2. Remove the Main Paper Handling Assembly (RRP 9.36).
3. Reach in through the empty paper feeder and hold onto the No Paper Bracket.
4. With the other hand reach in through the empty Paper Handling Assembly cavity and push in on the
four latches holding the No Paper Bracket to the printer frame.
5. When you have released the latch, pull the Bracket down into the empty paper feeder.
6. Follow the wire coming out of the Low Paper Sensor and disconnect it from P/J106.
7. Remove the screw securing the Low Paper Sensor to the No Paper Bracket and remove the Sensor.
Replacement
1. Position the Low Paper Sensor against the No Paper Bracket so the Sensor wires are face the rear of
the printer.
2. Reposition the Sensor so the two holes in the Sensor line up with the screw hole and positioning tab
on the No Paper Bracket.
3. Use one screw to secure the Sensor to the Bracket.
4. Route the Sensor wire through the grommet hole in the frame, and reconnect the Sensor to P/J106.
5. Reinstall the No Paper Bracket by inserting the four latches of the Bracket up into the two cutouts in
the printer frame.
6. Push in on the latches and push up on the Bracket until the latches lock into place.
7. Reinstall the Main Paper Handling Assembly (RRP 9.36).
8. Reinstall Tray 1 into the printer.
magicolor 330 - Base Engine Service Manual
Removal and Replacement Procedures
9-43