Minolta magicolor 330 Service Manual page 363

RRP 9.107 Exit Chute Switch (PL10.2.13)
Removal
1. Remove the Lower Exit Assembly (RRP 9.101).
2. Squeeze the latches holding the Exit Chute Switch to the Lower Exit Assembly and remove the Switch.
Replacement
1. Position the Exit Chute Switch against the Lower Exit Assembly.
2. Line up the positioning pin and the two latches on the Sensor with the three holes in the Lower Exit
Assembly.
3. Press the Sensor against the Assembly until the latches snap into place.
4. Reinstall the Lower Exit Assembly (RRP 9.101).
magicolor 330 - Base Engine Service Manual
Removal and Replacement Procedures
9-219