Cyan Toner Empty - Minolta magicolor 330 Service Manual

3.4 - Error Message: Cyan Toner Empty
Cyan image density is too low.
Logic control on the MCU PWB detected that the ADC Sensor reads the cyan patch density as being below specifica-
tion and that the reading is either slow to raise or does not raise after the printer attempts to increase density.
Step
SUSPECT COMPONENTS
The following components are associated with this specific prob-
lem. One or more of these components may have failed partially or
completely. If you cannot isolate the problem using this FIP,
replace each component listed below, one at a time, until the prob-
lem disappears.
• Cyan Developer (RRP 9.64)
• Cyan Developer Assembly (RRP 9.63)
• LVPS (RRP 9.119)
• HVPS (RRP 9.120)
• Developer Clutch Assembly (RRP 9.117)
1
Replace the Cyan Toner Cartridge with a new one (RRP 9.57)
Does the error message still appear?
2
Replace the Dispense Motor (RRP 9.116)
Does the error message still appear?
3
Replace the ADC Sensor (RRP 9.50)
Does the error message still appear?
4
Replace the OPC Drum (RRP 9.48)
Does the error message still appear?
magicolor 330 - Base Engine Service Manual
Actions and Questions
Primary FIPS: Error Messages
Yes No
Go to step 2 Problem
solved
Go to step 3 Problem
solved
Go to step 4 Problem
solved
Replace the Problem
MCU PWB solved
(RRP 9.123)
3-7