Minolta magicolor 330 Service Manual page 119

5.10 - Residual Image or Ghosting, continued
Step
FUSER INSPECTION
1. Generate a test print and slide the Fuser Assembly out of the
printer just as the sheet of paper exits the Fuser.
6
2. Inspect the image on the sheet of paper just after the paper exits
the Fuser.
Is there a normal test print image on the sheet of paper befor
entering the Fuser but the image has ghost images after it exits
the Fuser?
1. Replace the Oil Roll Assembly (RRP 9.82).
2. Generate a test print.
7
3. Inspect the image on the sheet.
Is the image now normal, without ghost images, as it exits the
Fuser?
magicolor 330 - Base Engine Service Manual
Actions and Questions
Primary Fault Isolation Procedures
Yes
Go to step 7
Problem Replace
Solved Pressure
(RRP 9.83) and
the Heat Roll
(RRP 9.84)
No
the
Roll
5-23