Adjust Opt3 Bin - Minolta magicolor 330 Service Manual

3.26 - Error Message: Adjust OPT3 Bin
There is a problem with the OPT3 tray or bin.
Logic control on the MCU PWB did not detect a paper tray installed in the OPT3 bin. Note: the Engine Diagnostic
Menu may refer to the the OPT3 Bin no paper sensor as Tray 4.
Step
SUSPECT COMPONENTS
The following components are associated with this specific prob-
lem. One or more of these components may have failed partially
or completely. If you cannot isolate the problem using this FIP,
replace each component listed below, one at a time, until the prob-
lem disappears.
• Wiring and connectors linking the LCIF to the Base Engine
• Wiring and connectors linking the components
1
PAPER TRAY INSPECTION
1. Remove the paper tray from OPT3 bin.
2. Inspect the Size Actuators at the rear of the Tray.
Are the Actuators intact and free of damage?
2
Replace the OPT3 Bin Switch Assembly (LCIF RRP 6.13)
Does the error message still appear?
3
Replace the Feeder PWB (LCIF RRP 6.10)
Does the error message still appear?
4
Replace the MCU PWB (RRP 9.123)
Does the error message still appear?
magicolor 330 - Base Engine Service Manual
Actions and Questions
Primary FIPS: Error Messages
Yes No
Go to step 2 Replace
Paper Tray.
Go to step 3 Problem
solved
Go to step 4 Problem
solved
Go to suspect Problem
components solved
the
3-29