Minolta magicolor 330 Service Manual page 297

RRP 9.74 BTR Cam Solenoid (PL8.1.15)
Removal
1. Remove the High Voltage Power Supply (RRP 9.120).
2. Remove the screw securing the BTR Cam Solenoid to the BTR Side Bracket and remove the Sole-
noid.
3. Disconnect P/J 63 from the BTR Cam Solenoid.
Replacement
1. Reinstall the BTR Cam Solenoid onto the BTR Side Bracket.
2. Line up with positioning hole and screw hole on the Solenoid with the positioning tab and screw hole
on the Side Bracket.
Make sure the top edge of the BTR Cam Solenoid Bracket is mounted parallel with the top
edge of the BTR Side Bracket. Image quality problems may result if the Solenoid Bracket
is not parallel.
3. Use one screw to secure the BTR Cam Solenoid to the BTR Side Bracket.
4. Reconnect P/J 63 to the BTR Cam Solenoid.
5. Reinstall the High Voltage Power Supply (RRP 9.120).
magicolor 330 - Base Engine Service Manual
Parallel
BTR Cam
Solenoid
Removal and Replacement Procedures
BTR Side Bracket
BTR Cam Solenoid Bracket
RS2027X
9-153