Minolta magicolor 330 Service Manual page 209

RRP 9.30 MSI Roll Assembly (PL4.2.9)
Removal
1. Remove the MSI Top Cover Assembly (RRP 9.26).
2. Unhook the Pick Up Spring from the Pick Up Gear.
3. Release the latches holding the Pick Up Gear to the Pick Up Shaft and slide the Pick Up Gear, Pick Up
Cam Gear, and Lever Stopper off of the Shaft.
4. Remove the E ring securing the rear shaft bearing to the rear of the MSI.
5. Remove the E ring securing the front shaft bearing to the front of the MSI.
6. Slide the MSI Roll Assembly out of the MSI.
Replacement
1. Reinstall the MSI Roll Assembly by sliding the front and rear of the Shaft into the front and rear cutouts
in the MSI.
2. Slide the front shaft bearing into the front bearing cutout and use an E ring to secure the bearing.
3. Slide the rear shaft bearing into the rear bearing cutout and use an E ring to secure the bearing.
4. Push down the arm of the Pick Up Solenoid as you slide the Lever Stopper, Pick Up Cam Gear, and
Pick Up Gear onto the Shaft.
The Pick Up Gear latches lock the Gears in place on the Shaft.
5. Hook the Pick Up Spring onto the Pick Up Gear.
6. Reinstall the MSI Top Cover Assembly (RRP 9.26).
magicolor 330 - Base Engine Service Manual
Removal and Replacement Procedures
9-65