Minolta magicolor 330 Service Manual page 40

Primary FIPS: Error Messages
3.24 - Error Message: Paper Jam Registration, continued
Step
6
UPPER TRAY FEED SOLENOID TEST
Enter Diagnostics and test the Upper/Tray 1 Feed Solenoid. The
Engine Diagnostic Menu may refer to the the Upper Tray as Tray
1.
Does the Upper/Tray 1 Feed Solenoid actuate when you run the
test?
7
PAPER PATH INSPECTION
1. Slide the Registration Transport out of the printer.
2. Inspect the lead edge of the jammed sheet of paper.
Did the Turn Rolls drive the sheet of paper into the Pre-Regis-
tration Rolls?
8
PRE-REGISTRATION ROLL TEST
1. Slide the Registration Transport out of the printer.
2. Slide a piece of paper between the Pre-Registration
Rolls.
3. Turn the green knob that is attached to the end of the
Pre-Registration Rolls.
Do the Pre-Registration Rolls drive the sheet of paper into the
Registration Sensor?
3-26
Actions and Questions Yes
Replace the
Upper/Tray 1
Feed Solenoid
(RRP 9.15)
Go to step 8
Replace the
Pre-Registra-
tion Clutch
(RRP 9.41)
magicolor 330 - Base Engine Service Manual
No
Replace
Upper/Tray 1
Feed Rolls
(RRP 9.14)
Replace the
Turn Roll
Assembly
(RRP 9.16)
Replace the
Pre-Registra-
tion Roll
Assembly
(RRP 9.40)