Minolta magicolor 330 Service Manual page 127

5.14 - Damaged Prints, continued
Step
TRAY 1 INSPECTION
Inspect Paper Tray 1 and Tray 1 Feeder Assembly for debris or obvi-
ously broken components that could be damaging the paper as it
8
feeds out of the Tray and into the printer.
Is Tray 1 and the Tray 1 Feeder free of debris or broken compo-
nents
REGISTRATION ROLL INSPECTION
1. Generate a test print and slide the Fuser Assembly out of the
printer just as the sheet of paper is moving through the Registra-
tion Rolls.
9
2. Carefully slide the Main Paper Handling Assembly out of the
printer and inspect the sheet of paper.
Is the sheet of paper undamaged as it leaves the Registration
Rolls?
2ND TRANSFER ASSEMBLY INSPECTION
1. Generate a test print and slide the Fuser Assembly out of the
printer just before the sheet of paper reaches the Fuser.
10
2. Slide the Fuser Assembly out of the printer and inspect the sheet
of paper.
Is the sheet of paper undamaged as it leaves the 2ND BTR?
FUSER INSPECTION
1. Generate a test print and slide the Fuser Assembly out of the
printer just as the sheet of paper exits the Fuser.
11
2. Slide the Fuser Assembly out of the printer and inspect the sheet
of paper.
Is the sheet of paper undamaged as it exits the Fuser?
FUSER FINGER INSPECTION
1. Slide the Fuser Assembly out of the printer.
12
2. Inspect Main Fuser for debris, broken or dislodged components;
such as the Fuser Fingers and the Upper Exit Guide.
Is the Main Fuser free of debris and broken or dislodged compo-
nents
magicolor 330 - Base Engine Service Manual
Actions and Questions
Primary Fault Isolation Procedures
Yes
Go to step 9 Clean Tray 1,
or replace the
broken compo-
nents or replace
the Tray
Go to step 10 Replace
Metal Registra-
tion Roll (RRP
9.43) and the
Rubber Regis-
tration
(RRP 9.44)
Go to step 11 Replace
2ND
Assembly
(RRP 9.75)
Go to step 13 Go to step 12
Go to step 13 Clean the Main
Fuser or reseat
or replace the
faulty compo-
nents
No
the
Roll
the
BTR
5-31