Minolta magicolor 330 Service Manual page 235

RRP 9.43 Metal Registration Roll (PL5.2.16)
Removal
1. Remove the Registration Clutch (RRP 9.42).
2. Remove the Registration Brake Clutch (RRP 9.46).
3. Remove the E ring securing the Out Gear at front end of the Metal Registration Roll and remove the
Gear.
4. Remove the rear bearing from the Metal Registration Roll.
5. Slide Metal Registration Roll to the rear, slide the front of the Roll out of the front bearing, and remove
the Roll from the Main Paper Handling Assembly.
Replacement
1. Insert the front end of the Metal Registration Roll into the front bearing.
2. Snap the rear of the Metal Registration Roll into the rear bearing notch in the Main Paper Handling
Assembly.
3. Slip the rear bearing over the rear end of the Metal Registration Roll and slide the bearing in place in
the Main Paper Handling Assembly.
4. Slide the Out Gear onto the front of the Metal Registration Roll and push it against the Main Paper
Handling Assembly.
5. Use an E ring to secure the Gear onto the end of the Metal Registration Roll.
6. Reinstall the Registration Brake Clutch (RRP 9.46).
7. Reinstall the Registration Clutch (RRP 9.42).
magicolor 330 - Base Engine Service Manual
Removal and Replacement Procedures
9-91