Minolta magicolor 330 Service Manual page 387

RRP 9.119 Low Voltage Power Supply (LVPS) (PL13.1.1)
Removal
1. Remove the Rear Cover (RRP 9.4).
2. Press in on the plug clip and disconnect P/J 35 from the top of the LVPS.
3. Press in on the plug clips and disconnect P/J 32 and P/J 33 from the LVPS.
4. Release the wire harness from the wire clip located at the top left of the LVPS.
5. Remove the four screws securing the LVPS to the printer frame - lift and remove the LVPS from the
printer frame.
Replacement
1. Move the wire harnesses out of the way and reinstall the LVPS onto the printer frame making sure you
hook the rear of the LVPS over the tab on the printer frame (see inset).
2. Line up the four screw holes in the LVPS with the four screw holes in the printer frame.
3. Use four screws to secure the LVPS to the printer frame.
4. Reconnect P/J 32 and P/J 33 to the LVPS.
The plug snaps into place.
5. Reconnect P/J 35 to the top of the LVPS.
The plugs snap into place.
6. Reinstall the Rear Cover (RRP 9.4).
magicolor 330 - Base Engine Service Manual
Removal and Replacement Procedures
9-243