Minolta magicolor 330 Service Manual page 309

RRP 9.80 Fuser Assembly (PL9.1.1)
Removal
1. Slide Tray 1 a few inches out of the printer so you can access the screw that prevents the Fuser
Assembly from sliding out of the printer.
2. Remove the screw securing the Fuser Assembly to the printer frame.
3. Slide the Fuser Assembly a few inches out of the printer.
4. Lift the end of the Fuser Assembly and pull the Assembly out of the printer.
Replacement
1. Lift the end of the Fuser Assembly as you insert the Assembly side rails into the guide wheels inside
the printer.
2. Lower the end of the Fuser Assembly and slide the Assembly into the printer.
3. Slide Tray 1 a few inches out of the printer.
4. Reinstall the screw to secure the Fuser Assembly to the printer frame.
magicolor 330 - Base Engine Service Manual
Removal and Replacement Procedures
9-165