Minolta magicolor 330 Service Manual page 311

RRP 9.81 Main Fuser Assembly (PL9.1.2)
Removal
1. Remove the Oil Roll Assembly (RRP 9.82).
2. Disconnect the P/Js that are located at the end of the Main Fuser Assembly.
3. Remove the two screws securing the Main Fuser Assembly to the Fuser Tray and lift the Assembly up
and out of the Tray.
4. Place the Main Fuser Assembly on a flat and stable work surface.
Replacement
1. Lower the Main Fuser Assembly onto the Fuser Tray.
2. User two screws to secure the Main Fuser Assembly to the Fuser Tray.
3. Reconnect the two P/Js that are located at the end of the Main Fuser Assembly.
4. Reinstall the Oil Roll Assembly (RRP 9.82).
5. Refer to Section 9 of this manual and reset to zero the two Life Counters for the Main Fuser Assembly.
magicolor 330 - Base Engine Service Manual
Removal and Replacement Procedures
9-167