Feeder Cover Missing - Minolta magicolor 330 Service Manual

Primary FIPS: Error Messages
3.56 - Error Message: Feeder Cover Missing
There is a problem with the Large Capacity Input Feeder Cover.
Logic control on the MCU PWB detected that the LCIF Feeder Cover Interlock is deactuated.
Step
SUSPECT COMPONENTS
The following components are associated with this specific prob-
lem. One or more of these components may have failed partially
or completely. If you cannot isolate the problem using this FIP,
replace each component listed below, one at a time, until the prob-
lem disappears.
• Wiring and connectors linking the components
1

FEEDER COVER MISSING

1. Open the Feeder Cover.
2. Firmly close the Feeder Cover.
Does the error message still appear?
2
LCIF FEEDER COVER SWITCH INSPECTION
1. Open the Feeder Cover.
2. Inspect the Feeder Cover Switch actuator that is located
near the top-rear of the Cover.
Is the actuator free of damage?
3
Replace the LCIF Cover Assembly (LCIF RRP 6.8)
Does the error message still appear?
4
Replace the Feeder Cover Switches (LCIF RRP 6.14)
Does the error message still appear?
5
Replace the Feeder PWB (LCIF RRP 6.10)
Does the error message still appear?
6
Replace the MCU PWB (RRP 9.123)
Does the error message still appear?
3-60
Actions and Questions Yes
Go to step 2
Go to step 4
Go to step 4
Go to step 5
Go to step 6
Go to suspect
components
magicolor 330 - Base Engine Service Manual
No
Problem
solved
Go to step 3
Problem
Solved
Problem
Solved
Problem
Solved
Problem
Solved