Minolta magicolor 330 Service Manual page 125

5.13 - Skewed Image, continued
Step
REGISTRATION ROLL INSPECTION
1. Generate a test print and slide the Fuser Assembly out of the
printer just as the sheet of paper is moving through the Registra-
tion Rolls.
5
2. Carefully slide the Main Paper Handling Assembly out of the
printer and inspect the position of the sheet of paper.
Is the sheet of paper parallel to the edges of the Paper Handling
Assembly as it leaves the Registration Rolls?
2ND BTR INSPECTION
1. Remove 2nd BTR Assembly (RRP 9.75)
2. Manually raise and lower the cam levers at the ends of the 2nd
BTR Assembly.
6
Are the cam levers undamaged?
When you raise the levers does the 2nd BTR lower and when you
release the levers does the 2nd BTR raise?
Do the cam levers have a strong spring action?
2ND BTR CAM ASSEMBLY INSPECTION
With the 2nd BTR Assembly still removed, inspect the 2nd BTR
7
Cam Assembly.
Are the cams undamaged?
magicolor 330 - Base Engine Service Manual
Actions and Questions
Primary Fault Isolation Procedures
Yes
Go to step 6 Replace
Metal Registra-
tion Roll (RRP
9.43) and the
Rubber Regis-
tration
(RRP 9.44)
Go to step 7 Replace
2ND
Assembly
(RRP 9.75)
Go to Suspect Replace
Components 2ND BTR Ca
Assembly
(RRP 9.73)
No
the
Roll
the
BTR
the
5-29