Minolta magicolor 330 Service Manual page 315

RRP 9.83 Pressure Roll (PL9.2.9)
Removal
1. Remove the Heat Roll Heat Rod (RRP 9.86).
2. Remove the Heat Roll (RRP 9.84).
3. Remove the Lower Guide Assembly (RRP 9.99).
4. Remove the screw securing the Fuser Inlet Plate to the Main Fuser Assembly and remove the Plate.
5. Lift the Pressure Roll front and rear bearings off of the front and rear Fuser Brackets and remove the
Pressure Roll.
Replacement
1. Reinstall the Pressure onto the Main Fuser Assembly so the front and rear bearings rest on the front
and rear Fuser Brackets.
The bearing rings should rest on the inside of the Fuser Brackets.
2. Reinstall the Fuser Inlet Plate to the Main Fuser Assembly and use one screw to secure the Plate to
the Assembly.
3. Reinstall the Lower Guide Assembly (RRP 9.99).
4. Reinstall the Heat Roll (RRP 9.84).
5. Reinstall the Heat Roll Heat Rod (RRP 9.86).
magicolor 330 - Base Engine Service Manual
Removal and Replacement Procedures
9-171