Minolta magicolor 330 Service Manual page 225

RRP 9.38 Pre-Registration Chute Assembly (PL5.1.5)
Removal
1. Slide the Main Paper Handling Assembly out of the printer.
You do not need to remove the Assembly.
2. Remove the two screws securing the Pre-Registration Chute Assembly to the Main Paper Handling
Assembly and remove the Chute Assembly.
Replacement
1. Position the Pre-Registration Chute Assembly with the pinch rolls facing down.
2. Reinstall the Pre-Registration Chute Assembly onto the Main Paper Handling Assembly, making sure
you line up the two positioning holes in the Chute Assembly with the two positioning tabs on the Main
Paper Handling Assembly.
3. Use two screws to secure the Pre-Registration Chute Assembly to the Main Paper Handling Assembly.
4. Close the Main Paper Handling Assembly.
magicolor 330 - Base Engine Service Manual
Removal and Replacement Procedures
9-81